How to fix a wall mirror
So, you’ve bought your new wall mirror and now you need to hang it. Once you've decided where you want it, the main consideration is its weight. Mirrors can be very heavy so must be attached safely… you don’t want seven years bad luck on you! Before you start hammering in any nails, there are a few important things you need to consider.
You do not want to hang your mirror, or anything, where a nail may hit any electric cables. These cables usually run up or down vertically from light switches. You’ll want to get hold of a detector, a handheld device that locates cables, pipes, and studs in your walls. You’ll have studs only if you have hollow stud walls. Studs are the wooden struts that plaster board is attached to, and it is on these that you will want to attach your hooks or screws for hanging.
If you have stone walls you will need masonry nails, but for some heavy mirrors (or pictures), you might also need to use a screw and rawlplug – in which case you’ll probably need a drill too. Your mirror should come with the necessary fittings already attached or in the package, and these should be suitable for the mirror’s weight.In addition to the fixings for the mirror and wall, other tools you’ll probably need are a tape measure, a pencil for marking the wall and a spirit level. You’ll probably want another person with you too if the mirror is heavy.
If your mirror comes with two D-rings and a metal or string cord, you might need to attach the cord to the rings. Make sure you tie an unslippable knot if it’s a string cord, or for metal, twist the cable securely together with it doubled over for at least two inches. For D-rings, you’ll need one or two picture hooks securely affixed to your wall and carefully measured so the mirror hangs straight, centred and without the hooks showing!
If your mirror has a keyhole fixing or a serrated plate on the back, you’ll need a heavy duty nail, pin or screw with rawlplug. Heavier mirrors tend to come with strap hangers (that look a little bit like a short belt) for which you will need to attach J-hooks to the wall. Mirror plates and flush plates are the other fixings that mirrors tend to come with – some plates are designed to be visible on the top rim of the mirror. Again, good quality screws and rawlplugs are required for these methods.
Only use velcro adhesive pads for the lightest of wall hangings.